Installation
On UNIX-like systems, the installation is very simple:
- Download the code from http://software.uninett.no/radsecproxy/.
Verify its authenticity (either by verifying the PGP signature as can be found right next to the download itself, or by comparing the SHA256 checksum with the reference list in http://software.uninett.no/radsecproxy/sha256.txt ).
- Unpack the code.
- Navigate into the unpacked directory (the base directory)
- type the usual UNIX compilation sequence (the configure switch about F-Ticks is only needed if you need that functionality):
Code Block |
---|
./configure --enable-fticks make make check make install |
4. After compiling and installing, the executable
Code Block |
---|
radsecproxy |
is in the installed directory. Execution of the installed binaries does not require root rights.
5. Copy the template configuration file below into
Code Block |
---|
/etc/radsecproxy.conf |
6. Create the directory /etc/radsecproxy.d/certs/ca/. The template configuration file requires this directory to contain the accredited CA root certificates and the corresponding Certificate Revocation Lists (CRLs) in their OpenSSL hash form. See this section for information about the CA download.
7. Fill the lines marked with _STUFF_ with the required information as explained below.
8. Start radsecproxy and enjoy (for first-time use, starting it with the -f option is recommended, it will start radsecproxy in the foreground and show some verbose startup messages).