...
Establish access to the controller by using a serial console and configure the initial settings for example as follows.
| Code Block |
|---|
Welcome to the Cisco Wizard Configuration Tool
Use the '-' character to backup
System Name [Cisco_b2:e2:83]: <your_system_name>
Enter Administrative User Name (24 characters max): <your_username>
Enter Administrative Password (24 characters max): <your_password>
Re-enter Administrative Password : <your_password>
Service Interface IP Address Configuration [none][DHCP]: DHCP
Enable Link Aggregation (LAG) [yes][NO]: NO
Management Interface IP Address: esim. xxx.yyy.zzz.1
Management Interface Netmask: <your_network_mask>
Management Interface Default Router: <your_router's_IP_address>
Management Interface VLAN Identifier (0 = untagged): <0 tai 1>
Management Interface Port Num [1 to 2]: 1
Management Interface DHCP Server IP Address: esim. xxx.yyy.zzz.2
AP Transport Mode [layer2][LAYER3]: <layer2 jos kontrolleri ja tukiasemat sijaitsevat samassa verkossa, layer3 jos välissä on reititetty verkko>
AP Manager Interface IP Address: esim. xxx.yyy.zzz.3
AP-Manager is on Management subnet, using same values
AP Manager Interface DHCP Server (xxx.yyy.zzz.2):
Virtual Gateway IP Address: xxx.yyy.zzz.www
|
Access Control Lists
After the initial setup, the access control (ACL) list needs to be configured, in order to prohibit unauthorized access to the controller. Choose SECURITY and then Access Control Lists | Access Control Lists and create an ACL by pressing New... The ACL shoud include at least
...