Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

FreeRADIUS is a very versatile and freely available RADIUS server under the GPL license. Setting up FreeRADIUS as an SP is a rather straightforward task, since it merely needs to forward requests from NASes to other RADIUS servers. In particular, it does not need to authenticate users. The following configuration enables your FreeRADIUS server to be an eduroam SP. At the same time, it is the baseline from which to establish an eduroam IdP configuration, if that is envisaged for a later stage.

Version information

This documentation is current as of FreeRADIUS 2.1.10.

Installation

FreeRADIUS is written in C and can be compiled with the usual UNIX compilation sequence. After unpacking the source into a directory of your choice, do

./configure --prefix=<your preferred install dir> --sysconfdir=<your preferred configuration base dir>
make
make install

In the examples below, we assume the installation is done for --prefix=/usr/local/freeradius/ and the configuration dir is --sysconfdir=/etc

Sample config directory

Base configuration / logging / F-Ticks

Client definition

FreeRADIUS defines the connected RADIUS clients in the file /etc/raddb/clients.conf. This file needs to hold all your connected Access Points and/or wired eduroam-enabled switches. You set a shared secret for each client and define these in the config file as follows:

 client antarctica-access-point-1 {
    ipaddr         = 172.25.1.55
    netmask        = 32
    secret         = yoursecret12345
    shortname      = southpole-11g
    virtual_server = eduroam
}

There are more (optional) settings for clients; please consult the comments in clients.conf for more detail. One option, the "virtual_server" one, enables your RADIUS server to serve more purposes than only eduroam: you can define several other virtual servers for other RADIUS purposes, and link clients to these. That is beyond the scope of this documentation, though.

If you want to connect your clients over IPv6, the syntax is only slightly different:

 client antarctica-access-point-2 {    ipv6addr       = 2001:db8:1:789::56
    netmask        = 128
    secret         = yoursecretABCDE
    shortname      = southpole-11n
    virtual_server = eduroam
}

Request forwarding

FreeRADIUS contains a wealth of options to define how requests are forwarded. These options are defined in the file /etc/proxy.conf. For a single eduroam SP, these may seem overkill, but the required definitions for that purpose are rather static. Assuming you have two upstream servers to forward requests to, the following configuration will set these up - you only need to change the IP addresses and shared secrets in home_server stanzas.

proxy server {
        default_fallback        = yes
}

home_server antarctica-flr-1 {
        type                    = auth+acct
        ipaddr                  = 172.20.1.2
        port                    = 1812
        secret                  = secretstuff
        status_check            = status-server
}

home_server antarctica-flr-2 {
        type                    = auth+acct
        ipv6addr                = 172.25.9.3
        port                    = 1812
        secret                  = secretstuff
        status_check            = status-server
}

home_server_pool EDUROAM {
        type                    = fail-over
        home_server             = antarctica-flr-1
        home_server             = antarctica-flr-2}

realm DEFAULT {
        pool                    = EDUROAM
        nostrip
}

Goodies

Caveats

  • No labels